Contents of the DISKWIPE.DOC file
DISKWIPE PROGRAM INSTRUCTIONS
To use DISKWIPE, type the following from the DOS prompt ( A> ).
DISKWIPE [?:] [/B]
?: = The drive in which you will put the disk to be wiped.
/B = If you wish to wipe both sides (preferable) enter this operand.
The default is side 0 only. You will notice additional prompts
when doing a two-sided wipe.
WARNING: THIS PROCEDURE WILL TOTALLY ERASE THE DISK , INCLUDING FORMATTING.
NOTE: DISKWIPE will work on an AT but only on the 320/360K disc drive.