Zephyr 4 - FoxPro2-compatible data base mgmt.
for non-programmers. Build data base apps in
minutes not months with the performance of an
IBM mainframe! Built-in report writer, label
and form letter generator. Can be loaded as a
20K TSR and supports .PCX graphics fields. A
product of Ward Mundy Software, P.O. Box 1169
Atlanta, GA 30301. Ph: 10288-0-700-WARD-MUNDY

Installing Zephyr from BBS zipped files:

Unzip each of the three distribution .ZIP files for Zephyr as you normally do.

After EACH .ZIP file is unzipped, copy its contents to a floppy which matches
the drive type of your Drive A floppy disk. Copy ONLY the file names shown
below, or you may run out of room on your floppy diskette.

If your Drive A floppy is a high density (1.2MB or higher) drive, the contents
of all three .ZIP files can be unzipped and then copied to the same floppy.
Otherwise, you will need to copy the contents of each unzipped file to a
separate floppy. They should be numbered 1, 2, 3 with the following files
being copied to each diskette:

Disk 1: INSTALL.BAT, INSTALL.OVL, ZEPHYR4.001
Disk 2: ZEPHYR4.002
Disk 3: ZEPHYR4.003

Please NOTE: Copying the correct files to the correct disk number is crucial.
If the files are not on the correct disks, the software cannot be installed!

Once you have copied the files to the diskette(s) as shown above, you can
install the software by inserting Diskette 1 in Drive A and typing A:INSTALL.