Category : Dbase (Clipper, FoxBase, etc) Languages Source Code
Archive   : DSCAR3.ZIP
Filename : INSTALL.BAT

 
Output of file : INSTALL.BAT contained in archive : DSCAR3.ZIP

echo off
cls
echo d S C A R V E R S I O N
echo d S C A R V E R S I O N
echo d S C A R V E R S I O N
echo d S C A R V E R S I O N
echo d S C A R V E R S I O N
echo d S C A R V E R S I O N
echo d S C A R V E R S I O N
echo -------------------------
echo ***** *****
echo * * *
echo **** * *
echo * * *
echo ***** * *****
echo.
if /%1==/ goto ERROR
:GO
echo If you are NOT currently logged into the drive you want dSCAR v3.0
echo installed in, hit CTRL-C to abort. Otherwise, press any key.
pause >nul
echo.
echo Copying DSCAR.EXE from %1 to current drive & directory
copy %1DSCAR.EXE >nul
echo.
echo If you are mainly using Clipper or FoxBase, you may specify which
echo one you are using.
echo.
%1askyn "Are you using Clipper?"
if errorlevel 1 goto FOX
%1use_clip
goto END
:FOX
%1askyn "Are you using FoxBase?"
if errorlevel 1 goto END
%1use_fox
goto END
:ERROR
echo Follow these steps to install dSCAR:
echo.
echo 1) Log into the drive and directory you want dSCAR installed in.
echo 2) Put the original dSCAR disk into the disk drive.
echo 3) Run the install batch file by specifying the drive letter
echo where dSCAR is located, like this:
echo.
echo %0 A:
echo.
echo In this case we assumed dSCAR was located on drive A:
:END
echo.