Category : Alternate Operating Systems - Quarterdeck DesqView, CP/M, etc
Archive   : QWAUG92.ZIP
Filename : KBMOUSE.TEC

 
Output of file : KBMOUSE.TEC contained in archive : QWAUG92.ZIP

ID:KM Keyboard Mouse Key
Quarterdeck Technical Note #117
by Stan Young
last revision: 10 February 1992

One of the problems that affects some DESQview users that do not have a
mouse is that they may on occasion inadvertently activate the DESQview
Keyboard Mouse. The Keyboard Mouse is activated when you tap the Control key
all by itself. When this happens, you get a beep and a diamond shaped cursor
appears on the screen. At this point, if you move the cursor keys the diamond
cursor moves and the normal cursor action for the program you were running is
disabled. If you tap the control key again, you get a double beep and the
diamond cursor will go away and cursor control will return to your
application.
This is all quite normal. The Keyboard Mouse is provided in DESQview to
maintain IBM's "TopView" compatibility, since TopView/DESQview specific
applications could require a mouse. Since TopView defines the Control key as
the key to activate the keyboard mouse, this is the DESQview default.
However, some users who may have a tendency to activate the Keyboard
Mouse by accident may wish to make it more difficult to turn on. With DV
2.26, simply run the DESQview Setup program, choose Advanced Setup, and select
"K" for Keyboard. Select Y for "Change system keys? (Y/N)".
Change the Line for Keyboard Mouse so that the Keyboard Mouse Key is
changed from "C" to "0" for disabled. Then hit Enter four times, which
returns you to the DOS prompt.
The following method is favored by tech support for versions of Desqview
prior to DV 2.26:

First, run the DESQview Setup Program. Take the Advanced Setup and
select "K" for Keyboard. Move down to the option that says "Change
system keys? (Y/N)" and type "Y." This takes you to another menu for
defining the system keys. Change the line for Keyboard Mouse as shown
below.

Key to Press Key(s) to Hold Down
Key Which Alt Shift Ctrl

"Keyboard Mouse" Key C E N N N

This necessitates changing only the "Key to Hold Down/Ctrl" to "N."
After doing this, hit the Enter key and keep hitting it until you have backed
out of Setup to the DOS prompt. Restart DESQview; now, you cannot activate
the Keyboard Mouse since you cannot both press the Control Key and not be
holding it down. Setting the "Key(s) to Hold Down" to "N" for the same key
you have chosen in "Key to Press" will keep any of the system keys from
working. For more information on this, read technote #196, "Changing your
DESQview System Keys."

************************************************************************
*This technical note may be copied and distributed freely as long as it*
*is distributed in its entirety and it is not distributed for profit. *
* Copyright (C) 1990-2 by Quarterdeck Office Systems *
************************ E N D O F F I L E *************************